Fault Code Descriptions; 00000 001) Motor Control Module Fault; 00000 111) Display Module Fault; 00001 001) Location Switch Error - Fisher & Paykel GWL03US Service Manual

10.2 FAULT CODE DESCRIPTIONS

Failures in operation are diagnosed by the washer. It will shut down the washer and display a fault
code on the CYCLE PROGRESS LED's whilst continuously beeping.
If a fault condition has occurred, first remove the power plug from the wall socket for at least 15
seconds, and then insert it again.
Operate the washer in the mode in which the failure occurred and if the condition recurs, repair by
parts replacement as described below.

1. (00000 001) MOTOR CONTROL MODULE FAULT

The Motor Controller Module has found a memory error.
Action
Replace Motor Control Module.
2. (00000 010) MOTOR CONTROL MODULE FAULT
An error has been encountered when trying to read the pressure sensor.
Action
Replace Motor Control Module.
3. (00000 011) MOTOR CONTROL MODULE FAULT
The Motor Controller Module has found a memory error.
Action
Replace Motor Control Module.
6. (00000 110) MOTOR CONTROL MODULE FAULT
The Motor Control Module has received an incorrect signal from the pressure sensor.
Action
Replace Motor Control Module.

7. (00000 111) DISPLAY MODULE FAULT

The Display Module has found a memory fault.
Action
Replace Display Module.

9. (00001 001) LOCATION SWITCH ERROR

The Display location switch setting does not match that stored in the memory.
Action
1 If the Display Module has just been inserted into a console housing, then check that the two
plungers accurately locate onto the console housing. If this fault has appeared during normal
operation of the washer replace Display Module.
2 If the Motor Control Module has been changed the memory will have to be reset. This can be
done by entering and exiting the Option Adjustment mode. Push and hold START/PAUSE
then push POWER button.
36