Option Adjustment Mode - Fisher & Paykel SmartDrive Service Manual

The RECYCLE status can be identified when SmartDrive is first turned on at
the wall:
If the 3 rightmost rinse and spin LEDs are off, RECYCLE is off.
If the 3 rightmost rinse and spin LEDs are flashing, RECYCLE is on.
RECYCLE is a service aid only and should be left OFF in the customer's
home. To return to normal operation, and to reset the RECYCLE feature to
the default setting, disconnect SmartDrive from the power supply.
If a situation is encountered with a Phase 1.4, 4, 5 or 6 module where the
recycle feature is permanently programmed on, follow the following steps to
return the machine to normal operation:
• Enter diagnostic mode as normal.
• Press and hold the ADVANCE button. (When this button is first pressed,
the beep tone will sound. This is O.K.)
• While pressing the ADVANCE button, press the WATER LEVEL UP
button to toggle the RECYCLE feature off. A long beep will acknowledge
the setting has been retained in EEPROM. Press POWER to retain
selection.

Option Adjustment Mode

Smartdrive can be adjusted to operate under a number of different conditions
OPTION ADJUSTMENT MODE may be used to customise Smartdrive.
Some of this information is available to the user in the 'Use and Care
Manual'. The features that can be adjusted in this mode are:-
a) Water Temperature
b) Rinse Options
c) Number of End of Cycle Warning Beeps GW (only)
d) Auto out of Balance Recovery – GW and MW (only)
e) Auto Water Level Adjustment - GW (only)
f) Water saver Rinse Volume Adjustment - GW (only)
NB. Phase 1-3. Entering Option Adjustment mode sets the size of Smartdrive
into EEPROM
8