P6 - Slim-Line Sata Optical Disk Drive Power Connector; 3.3 Efficiency; Ac Input Voltage Requirement; Table 11. P6 - Slim-Line Sata Optical Disk Drive Power Connector Pin-Out - Intel SR1630BC Technical Product Specification

Intel® Server System SR1630BC
3.2.5 P6 – Slim-line SATA Optical Disk Drive Power Connector
Connector housing: 6-pin SATA Power
Contact: 15u plating minimum
Table 11. P6 – Slim-line SATA Optical Disk Drive Power Connector Pin-out

3.3 Efficiency

The following table provides the required minimum efficiency level at various loading conditions.
These are provided at three different load levels: 100%, 50%, and 20%. Output should be
loaded according to the proportional loading method defined by 80 Plus. Efficiency should be
tested per 80 plus requirement.
Loading
Minimum Efficiency
3.4

AC Input Voltage Requirement

The power supply must operate within all specified limits over the following input voltage range,
shown in the following table. Harmonic distortion of up to 10% THD must not cause the power
supply to go out of specified limits. The power supply shall power off if the AC input is less than
75 VAC +/- 5 VAC range. The power supply should start up if the AC input is greater than 85
VAC +/- 4 VAC. Application of an input voltage below 85 VAC shall not cause damage to the
power supply, including a fuse blow.
Parameter
Voltage (110)
Voltage (220)
Frequency
20
Pin Signal
1 Reserved
2 +5 VDC
3 +5 VDC
4 Reserved
5 COM
6 COM

Table 12. Power Supply Efficiency

100% of Maximum
82%

Table 13. AC Input Rating

Minimum Rated
90 V 100-127 V
rms rms
180 V 200-240 V
rms rms
47 Hz
Intel order number E44588-003
22 AWG Color
N.C.
Red
Red
N.C.
Black
Black
50% of Maximum
85%
Maximum Start up VAC
140 V 85Vac +/-4Vac
rms
264 V
rms
63 Hz
Power Sub-System
20% of Maximum
82%
Power Off VAC
75Vac +/-5Vac
Revision 1.3