Intel
®
Server System R1000SPO Product Family System Integration and Service Guide
3.1
Slimline Optical Drive – Installation and Removal
This section provides installation and removal instructions for an optionally installed slimline SATA optical
drive for systems that support the option.
3.1.1
Slimline Optical Drive Installation
If installed, remove the optical drive bay filler plate from the chassis by removing the screws located
above it on the drive bay cover.
1. Remove the system top cover (see section 2.2.1)
2. Remove the screws on each side of the drive bay cover (see label A)
3. Remove the drive bay cover by sliding it back and then lifting it (see label "B")
32
Figure 34. Removing the Optical Disk Drive Filler
Figure 35. Removing the Drive Bay Cover