Firmware Versions Screen - Cisco 7940G Administration Manual

Firmware Versions Screen

Table 6-2
Message Component
REr
BCast
Phone Initialized
Elapsed Time
Port 1
Port 2
Firmware Versions Screen
The Firmware Versions screen displays information about the firmware that is running on the phone.
Table 6-3
To display the Firmware Version screen, follow these steps:
Procedure
Press the Settings button.
Step 1
Select Status.
Step 2
Select Firmware Versions.
Step 3
To exit the Firmware Version screen, press the Exit softkey.
Table 6-3
Message Component
Application Load ID
Boot Load ID
DSP Load ID
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SIP)
6-6
Chapter 6
Network Statistics Message Components (continued)
Description
Number of broadcast packets received by the phone
Number of broadcast packets transmitted by the phone
Amount of time that has elapsed since the phone last initialized.
Amount of time that has elapsed since the phone last rebooted.
Link state and connection of the PC port (for example,
Full-Duplex
auto-negotiated a full-duplex, 100-Mbps connection)
Link state and connection of the Network port
explains the information that is displayed on this screen.
Firmware Version Information
Description
Identifies the phone application running on the phone
Identifies the factory-installed load running on the phone
Identifies the DSP version on the phone.
Viewing Status, Statistics, and Firmware Information on the Cisco Unified IP Phone
means that the PC port is in a link up state and has
Auto 100 Mb
OL-15499-01