Editing Values - Cisco 7940G Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-1 Categories of Network Configuration Settings (continued)
Category Description
IP settings If you do not use DHCP in your network, you can make
IP settings manually.
Port settings Allow you to set the speed and duplex of the network
and access ports.
TFTP settings If you do not use DHCP to direct the phone to a TFTP
server, you must manually assign a TFTP server. You
can also assign an alternative TFTP server to use
instead of the one assigned by DHCP.
VLAN settings Allow you to change the administrative VLAN used by
the phone.
Related Topics
•
•
•
•
Viewing and Editing Options on the Network Configuration Menu
Table 4-2
to change them.
Before you can change an option on this menu, you must unlock options as described in the
and Locking Options" section on page
configuration options appear on the Cisco Unified IP Phones 7960G/7940G only if options are unlocked.
For information about the keys that you can use to edit options, see the
page
Table 4-2 Network Configuration Menu Options
Option Description
DHCP Server IP address of the Dynamic Host Configuration Protocol
(DHCP) server from which the phone obtains its IP address.
MAC Address Unique Media Access Control (MAC) address of the phone. Display only—cannot configure.
Host Name Unique host name that the DHCP server assigned to the
phone.
Domain Name Name of the Domain Name System (DNS) domain in which
the phone resides. You can overwrite this value if the
Alternate Domain option is set to Yes.
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SIP)
OL-15499-01
Displaying a Configuration Menu, page 4-2
Unlocking and Locking Options, page 4-2
Editing Values, page 4-3
Network Configuration Menu, page 4-4
describes the options on the Network Configuration menu and, where applicable, explains how
4-3.
Option on Network Configuration Menu
IP Address
Default Router 1-5
Subnet Mask
Domain Name
DNS Server 1-5
SW Port Configuration
PC Port Configuration
TFTP Server 1
Alternate TFTP Server
TFTP Server 2
Admin. VLAN Id
4-2. The Edit, Yes, or No softkeys for changing network
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
Network Configuration Menu
"Unlocking
"Editing Values" section on
4-5