Upgrading On A Set-By-Set Basis - Avaya 4602 Administrator's Manual

Administering 4602 SIP Telephones

Upgrading on a Set-By-Set Basis

This procedure resets all the parameters H.323 code uses to their default values, including
resetting the SIG flag to the H.323 default value.
1. Use the administrator's Web interface of the SIP phone you want to convert. Go to the
Network Settings page and make sure the Configuration HTTP Server IP Address is
properly set.
2. Go to the Firmware Update page. Specify the special conversion version of the H.323 boot
binary (sipto323XXXX.ebin) as the File to download.
3. Click Download Now to download the file.
The phone downloads the file. When completed, the message Firmware upgrade
successful displays.
4. Click Reset to reset the phone.
The phone restarts, looking to the TFTP server to download a script file. The messages
Starting and DHCP, press * for Setup display.
Note:
If you are not using DHCP, you must manually configure the set. Use the local
Note:
ADDR command to configure an IP address, subnet mask, gateway, and TFTP
server into the phone before proceeding.
5. Press * to enter the address configuration command.
The phone displays phone=xxx.xxx.xxx.xxx, new=.
6. Press * several times to scroll through the values without making changes. When the
message no new values, #=OK displays, press #.
The display goes blank.
7. Press Mute R E S E T # (Mute 73738 #).
8. Press # to reset all values, then press # again to restart the phone.
The script specifies a new boot and/or application file, which is then downloaded. After the
phone restarts, it runs using H.323.
20 4602 SIP Telephone SIP Release 1.2 Administrator's Guide