Table of Contents
Advertisement
11) The device shall drive the first word of the data transfer onto DD (15:0). This step may occur
when the device first drives DD (15:0) in step (10).
12) To transfer the first word of data the device shall negate DSTROBE within t
has negated STOP and asserted HDMARDY-. The device shall negate DSTROBE no sooner
than t
after driving the first word of data onto DD (15:0).
DVS
5.5.3.2 The data in transfer
The following steps shall occur in the order they are listed unless otherwise specifically allowed
(see 5.6.3.3 and 5.6.3.2 for specific timing requirements):
1) The device shall drive a data word onto DD (15:0).
2) The device shall generate a DSTROBE edge to latch the new word no sooner than t
changing the state of DD (15:0).
frequently than t
rising or two falling DSTROBE edges more frequently than 2t
mode.
3) The device shall not change the state of DD (15:0) until at least t
DSTROBE edge to latch the data.
4) The device shall repeat steps (1), (2) and (3) until the data transfer is complete or an Ultra
DMA burst is paused, whichever occurs first.
5.5.3.3 Pausing an Ultra DMA data in burst
The following steps shall occur in the order they are listed unless otherwise specifically allowed
(see 5.6.3.4 and 5.6.3.2 for specific timing requirements).
a) Device pausing an Ultra DMA data in burst
1)
The device shall not pause an Ultra DMA burst until at least one data word of an Ultra
DMA burst has been transferred.
2)
The device shall pause an Ultra DMA burst by not generating DSTROBE edges.
NOTE - The host shall not immediately assert STOP to initiate Ultra DMA burst
termination when the device stops generating STROBE edges. If the device does not
negate DMARQ, in order to initiate ULTRA DMA burst termination, the host shall
negate HDMARDY- and wait t
3)
The device shall resume an Ultra DMA burst by generating a DSTROBE edge.
b) Host pausing an Ultra DMA data in burst
1)
The host shall not pause an Ultra DMA burst until at least one data word of an Ultra
DMA burst has been transferred.
2)
The host shall pause an Ultra DMA burst by negating HDMARDY-.
The device shall generate a DSTROBE edge more
for the selected Ultra DMA Mode. The device shall not generate two
CYC
before asserting STOP.
RP
C141-E110-02EN
after the host
FS
DVS
for the selected Ultra DMA
CYC
after generating a
DVH
5 - 85
after
Advertisement
Table of Contents
