Table of Contents
Advertisement
10) The device shall latch the host's CRC data from DD (15:0) on the negating edge of
DMACK-.
11) The device shall compare the CRC data received from the host with the results of its own
CRC calculation. If a miscompare error occurs during one or more Ultra DMA bursts for
any one command, at the end of the command the device shall report the first error that
occurred (see 5.5.5).
12) The device shall release DSTROBE within t
13) The host shall not negate STOP no assert HDMARDY- until at least t
DMACK-.
14) The host shall not assert DIOR-, CS0-, CS1-, DA2, DA1, or DA0 until at least t
negating DMACK.
b) Host terminating an Ultra DMA data in burst
The following steps shall occur in the order they are listed unless otherwise specifically
allowed (see 5.6.3.6 and 5.6.3.2 for specific timing requirements):
1)
The host shall not initiate Ultra DMA burst termination until at least one data word of an
Ultra DMA burst has been transferred.
2)
The host shall initiate Ultra DMA burst termination by negating HDMARDY-. The host
shall continue to negate HDMARDY- until the Ultra DMA burst is terminated.
3)
The device shall stop generating DSTROBE edges within t
HDMARDY-.
4)
If the host negates HDMARDY- within t
edge, then the host shall be prepared to receive zero or one additional data words. If the
host negates HDMARDY- greater than t
edge, then the host shall be prepared to receive zero, one or two additional data words.
The additional data words are a result of cable round trip delay and t
device.
5)
The host shall assert STOP no sooner than t
shall not negate STOP again until after the Ultra DMA burst is terminated.
6)
The device shall negate DMARQ within t
shall not assert DMARQ again until after the Ultra DMA burst is terminated.
7)
If DSTROBE is negated, the device shall assert DSTROBE within t
asserted STOP. No data shall be transferred during this assertion. The host shall ignore
this transition on DSTROBE. DSTROBE shall remain asserted until the Ultra DMA
burst is terminated.
8)
The device shall release DD (15:0) no later than t
9)
The host shall drive DD (15:0) no sooner than t
DMARQ. For this step, the host may first drive DD (15:0) with the result of its CRC
calculation (see 5.5.5).
after the host negates DMACK-.
IORDYZ
after the device has generated a DSTROBE
SR
after the device has generated a DSTROBE
SR
after negating HDMARDY-. The host
RP
after the host has asserted STOP. The device
LI
after negating DMARQ.
AZ
C141-E110-02EN
after negating
ACK
of the host negating
RFS
timing for the
RFS
after the host has
LI
after the device has negated
ZAH
after
ACK
5 - 87
Advertisement
Table of Contents
