Table of Contents
Advertisement
*4 Normalized attribute value
The current attribute value is the normalized raw attribute data. The value varies between 01h
and 64h. The closer the value gets to 01h, the higher the possibility of a failure. The device
compares the attribute values with thresholds. When the attribute values are larger than the
thresholds, the device is operating normally.
*5 Worst ever normalized
This is the worst attribute value among the attribute values collected to date. This value
indicates the state nearest to a failure so far.
*6 Raw attribute value
Raw attributes data is retained.
*7 Off-line data collection status
Values
00h or 80h
01h or 81h
02h or 82h
03h or 83h
04h or 84h
05h or 85h
06h or 86h
40h to 7Fh
C0h to FFh
07h to 3Fh
87h to BFh
If bit [7] is 1, it indicates that automatic off-line data collection function is enabled.
*8 Self Test execution status byte [16Bh]
Bit 0-3: Self Test remain time.
The values in these bits indicate the remaining percentage (0% - 90%) of Self Test until
completion by 0h-9h.
Bit 4-7: Self Test execution status
00h: Self Test has been completed normally. Otherwise Self Test has not
performed.
01h: Self Test has been interrupted by host.
02h: Self Test has been interrupted by the soft/hard reset from the host.
Off-line data collection is not started.
Reserved
Off-line data collection has been completed without error.
Reserved
Off-line data collection has been suspended by an interrupt
command from the host.
Off-line data collection has been aborted by an interrupt
command from the host.
Off-line data collection has been aborted with a fatal error. (Not
used)
Vendor unique (Not used)
Reserved
C141-E110-02EN
Description
5 - 57
Advertisement
Table of Contents
