Table of Contents
Advertisement
Pin 40 (Ground)
Pin 34
Pin 30 (Ground)
Pin 26 (Ground)
Pin 24 (Ground)
Pin 22 (Ground)
Pin 19 (Ground)
Pin 2 (Ground)
System Board
Connector
b) Host system that do support Ultra DMA modes greater than mode 2 shall either connect
directly to the device without using a cable assembly, or determine the cable assembly type.
Determining the cable assembly type may be done either by the host sensing the condition of
the PDIAG-:CBLID- signal (see Figure 3.12), or by relying on information from the device
(see Figure 3.13). Hosts that rely on information from the device shall have a 0.047 F
capacitor connected from the PDIAG-:CBLID- signal to ground. The tolerance on this
capacitor shall be 20% or less.
254.0 to 457.2 mm
(10 to 18 inch)
127.0 to 304.8 mm
(5 to 12 inch)
open
Symbolizes Pin 34
Conductor being cut
Position 1
Connector 1
Figure 3.11 Cable configuration
C141-E110-02EN
101.6 to 152.4 mm
(4 to 6 inch)
Pin 34 contact
(PDIAG-:CBLID- signal)
Connector 2
3 - 11
Advertisement
Table of Contents
