Table of Contents
Advertisement
MOON 700i Dual-Mono Integrated Amplifier
Remote Control Operation
Figure 3: FRM-3 Remote Control
____________________________________________________________________________________
Remote Control Operation
The MOON 700i Dual-Mono Integrated Amplifier uses the 'FRM-3' full function, all
aluminum backlit remote control (figure 3). It operates on the Philips RC-5
communication protocol and is can be used with other MOON components such as CD
Players, DAC's, Integrated Amplifiers, as well as other Preamplifiers.
The 'FRM-3' remote uses three AAA batteries (included). To install them, use a Phillips
head screwdriver #1 to remove the three screws located on the rear plate; insert the
batteries in the correct direction and then screw the rear plate back into place.
To operate the 700i with this remote control, you must first press the AMP button
located on the second row from the top.
The
power button switches the 700i between 'Standby' and 'On' mode.
The Balance
and Balance
arrow button causes a decrease in the volume level of the right channel; pressing the
right arrow button causes a decrease in the volume level of the left channel. The balance
adjustment operates in 1% increments. When the balance is equal for both channels, "
00
" will briefly appear in the front panel display. The range for the balance control
varies from "
100" for left channel only to "100
The Input
and Input
preamplifier's inputs, performing the identical function as the 'Input' buttons located on
the 700i's front panel
The Mute button, located between the input and volume buttons, reduces your volume
setting to zero, performing the identical function as the 'Mute' button located on the
700i's front panel.
The Vol
and Vol
buttons increase and decrease the volume level. From 30 to 80dB,
holding either button down results in 1.0dB volume changes; repeatedly pressing either
button very briefly results in 0.1dB volume changes.
The Disp button allows you to adjust the brightness of the digital display window. It also
provides you with the option of turning off the display, performing the identical function
as the 'Display' button located on the 700i's front panel.
Mon engages (and disengages) the Monitor loop, performing the identical function as
the 'Monitor' button located on the 700i's front panel.
buttons control channel balance; Pressing the left
" for right channel only.
buttons allow you to sequentially scroll through each of the
15
Advertisement
Table of Contents
