Table of Contents
Advertisement
Owner's Manual
Remote Control Operation
Figure 5: FRM-3 Remote Control
The MOON 850P Dual-Mono preamplifier uses the 'FRM-3' full function, all
aluminum backlit remote control (figure 5).
communication protocol and is can be used with other MOON components such as
CD Players, DAC's, Integrated Amplifiers, as well as other Preamplifiers.
The 'FRM-3' remote uses three AAA batteries (included). To install them, use a
Phillips head screwdriver #1 to remove the three screws located on the rear plate;
insert the batteries in the correct direction and then screw the rear plate back into
place.
To operate the 850P with this remote control, you must first press the AMP button
located on the second row from the top.
The
power button switches the 850P between 'Standby' and 'On' mode.
The Balance
and Balance
arrow button causes a decrease in the volume level of the right channel; pressing
the right arrow button causes a decrease in the volume level of the left channel. The
balance adjustment operates in 1% increments. When the balance is equal for both
channels, "
00
" will briefly appear in the front panel display. The range for the
balance control varies from "
channel only.
The Input
and Input
the preamplifier's inputs, performing the identical function as the 'Input' buttons
located on the 850P's front panel
The Mute button, located between the input and volume buttons, reduces your
volume setting to zero, performing the identical function as the 'Mute' button
located on the 850P's front panel.
The Vol
and Vol
buttons increase and decrease the volume level. From 30 to
80dB, holding either button down results in 1.0dB volume changes; repeatedly
pressing either button very briefly results in 0.1dB volume changes.
The Disp button allows you to adjust the brightness of the digital display window. It
also provides you with the option of turning off the display, performing the identical
function as the 'Display' button located on the 850P's front panel.
Mon engages (and disengages) the Monitor loop, performing the identical function
as the 'Monitor' button located on the 850P's front panel.
It operates on the Philips RC-5
buttons control channel balance; Pressing the left
100" for left channel only to "100
buttons allow you to sequentially scroll through each of
" for right
17
Advertisement
Table of Contents
