Table of Contents
Advertisement
MOON 700i Dual-Mono Integrated Amplifier
Software Setup
Assigning a custom label to an input:
1
Using the example from the previous page for configuring an input, repeat steps 1 through 5.
2
When "CUSTOM" appears in the display press the "OK" button. The display will show "................................." .
3
Rotate the volume control clockwise to scroll through the 26 letters of the English alphabet, first in uppercase and
then lowercase, followed by the numbers 0 through 9, and finally several miscellaneous symbols including the
space character. When you see the letter/number/symbol you wish to use, press "OK" to select it and then repeat
this step for the next character.
4
You must assign all 8 characters when creating a custom input label; In the event that your label requires only 5
characters, you will need to input a blank space for the remaining 3 characters.
5
Once you've filled the last position, press"OK" and "SAVED" will briefly appear in the display followed by "INPUTS".
6
Press the "Setup" button to exit from the Setup menu.
The MOON 700i is equipped with a 12 Volt trigger output. When an input is assigned to the 12 Volt trigger, the device
connected to the trigger will automatically start-up whenever you switch to that input. The default setting for all five inputs is
on. When you set the IR input to "Y", all inputs previously set to "Y" for that trigger will automatically be set to "N". Then the
trigger will be controlled exclusively by an external IR signal. The following example shows how to configure it:
6
You may either continue where we left off in the previous example by pressing "Setup" twice to return to the main
menu and the turn the volume control until "TRIGGER" appears in the display OR enter into the "Setup" mode
from the beginning by pressing the "Setup" button and rotating the volume control until "TRIGGER" appears in the
display.
7
Press "OK" and "B1 : Y" will appear in the display.
8
To disable the 12 Volt trigger, press "OK" and "B1 ? Y" appears in the display; rotate the volume control to
alternate from "Y" to "N" .
9
Press "OK" and "SAVED" will appear briefly in the display followed by "B1 : N".
10
To configure another input, rotate the volume control until that input appears in the display, then press "OK".
11
Repeat steps 3 and 4.
12
When you have finished with all of the inputs for the "TRIGGER" press the "Setup" button and "TRIGGER" will
appear in the display. From this point you can (i) exit from the Setup procedure by pressing the "Setup" button
again and "EXITING" will appear in the display or (iii) continue with the Setup procedure by disabling the infrared
remote sensor, changing the IR codes, resetting the 700i back to factory default status (see the following
examples) or configuring more inputs (example on previous page).
In the event that you want to control the MOON 700i using a wired aftermarket infrared remote control receiver with a
universal remote control, you can disable the IR sensor located on the front panel as follows:
1
You may either continue where we left off in the previous example by pressing "Setup" twice to return to the
main menu and the turn the volume control until "INFRARED" appears in the display OR enter into the "Setup"
mode from the beginning by pressing the "Setup" button and rotating the volume control until "INFRARED"
appears in the display.
2
Press "OK" and "NORMAL" will appear in the display.
3
To disable the MOON 700i's front panel IR sensor, rotate the volume control to alternate from "NORMAL" to
"DISABLED" .
4
Press "OK" and "SAVED" will appear briefly in the display followed by "INFRARED"
5
Press the "Setup" button to exit from the Setup menu.
____________________________________________________________________________________________________
Software Setup
(continued)
11
Advertisement
Table of Contents
