Remote Control Operation - moon i-7 Owner's Manual

MOON i-7 Dual-Mono Integrated Amplifier

Remote Control Operation

Figure 3: FRM-2 Remote Control
____________________________________________________________________________________
Remote Control Operation
The MOON i-7 Dual-Mono integrated amplifier uses the 'FRM-2' full function, all
aluminum remote control (figure 4).
protocol and can be used with other MOON components.
The 'FRM-2' remote uses three AAA batteries (included). To install them, use the
supplied Allen key to remove the three screws located on the back plate; insert the
batteries in the correct direction and then screw the back plate back into place.
To operate the i-7 with this remote control, you must first press the button labeled
'Preamp' in the top right corner.
The POWER button located on the upper left will switch the integrated amplifier to either
'Stand by' or 'On' mode.
The INPUT button performs in exactly the same way as the 'Input' button
located on the i-7's front panel, sequentially cascading through each of the
integrated amplifier's inputs.
The VOL+ and VOL– buttons increase and decrease the volume level. From 30 to 80dB,
holding either button down results in 1.0dB volume changes; repeatedly pressing either
button very briefly results in 0.1dB volume changes.
The and buttons control channel balance; Pressing the left arrow button causes a
decrease in the volume level of the right channel; pressing the right arrow button causes
a decrease in the volume level of the left channel. The balance adjustment operates in
1% increments. When the balance is equal for both channels, "
front panel display. The range for the balance control varies from "
channel only to "100 " for right channel only.
The MUTE button, located in the middle of the volume and balance buttons, performs the
identical function as the 'Mute' button located on the i-7 front panel.
It operates on the Philips RC-5 communication
00 " will appear in the
100" for left
14