Remote Control Operation - moon 430HA Neo Series Owner's Manual

Owner's Manual

Remote Control Operation

The Nēo 430HA Headphone Amplifier uses the 'CRM-2' full-function remote
control (figure 3). It operates on the Philips RC-5 communication protocol and
can be used with other Simaudio MOON components.
The 'CRM-2' remote uses two AA batteries (included). To install them, simply
slide the back plate off in the direction of the arrow; insert the batteries in the
correct direction and then replace the back plate.
To engage the 'CRM-2' remote for use with the Nēo 430HA Preamplifier, you
must first press the button labeled AMP.
The POWER button located on the upper left will switch the Headphone
Amplifier to either 'Standby' or 'On' mode.
The DISPLAY button turns the front panel display on and off. For units
equipped with the optional DAC, you can alternate between the volume level
and the digital input's sampling rate.
The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all available inputs. For example, to switch
from the "A1" to the "B1" input, press ◄ INPUT two (2) times. To switch from
the "B1" to the "A1" input, press INPUT ► two (2) times. Pressing and holding
down either of these buttons results in only a single change to the selected
input.
The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level. Pressing
▼ VOL results in a decrease in the volume level; Pressing VOL ▲ results in an
increase in the volume level. You may either press and hold these buttons
down or press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the "Mute" button a
second time will reinstate the output volume level back to its current setting.
NOTE: The ◄ BAL ► buttons don't affect the operation of the 430HA.
Figure 3: CRM-2 Remote Control
13