Table of Contents
Advertisement
Owner's Manual
Remote Control Operation
Figure 3: CRM-2
Remote Control
The Nēo 250i Integrated Amplifier uses the 'CRM-2' full-function remote
control (figure 4). It operates on the Philips RC-5 communication protocol
and is can be used with other MOON by Simaudio components.
The 'CRM-2' remote uses two AA batteries (included). To install them, simply
slide the back plate off in the direction of the arrow; insert the batteries in the
correct direction and then replace the back plate.
To engage the 'CRM-2' remote for use with the Nēo 250i Integrated
Amplifier, you must first press the button labeled AMP.
The POWER button located on the upper left will switch the integrated
amplifier to either 'Standby' or 'On' mode.
The 2 buttons labelled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all six (6) available inputs. For example, to
switch from the "CD" to the "VIDEO" input you may press either ◄ INPUT
three (3) times or INPUT ► three (3) times. Pressing and holding down either
of these buttons results in only a single change to the selected input.
The 2 buttons labelled ▼ VOL ▲ allow you to control the volume level.
Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲
results in an increase in the volume level. You may either press and hold these
buttons down or press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the "Mute" button a
second time will reinstate the output volume level back to its current setting.
NOTE: The 2 buttons labelled ◄ BAL ► and the DISPLAY button don't affect
the operation of the 250i.
11
Advertisement
Table of Contents
