Table of Contents
Advertisement
MOON P-5 Dual-Mono Preamplifier
Remote Control Operation
Figure 4: FRM Remote Control
____________________________________________________________________________________
Remote Control Operation
The MOON P-5 Dual-Mono preamplifier uses the 'FRM' full
function, all aluminum remote control (figure 4). It operates on the
Philips RC-5 communication protocol and is can be used with other
Simaudio MOON components such as the Eclipse CD Player, P-3
Preamplifier, AIR FM Tuner and both the i-5 and i-5080 integrated
amplifiers.
The 'FRM' remote uses three AAA batteries (included). To install
them, use the supplied Allen key to remove the three screws
located on the back plate; insert the batteries in the correct
direction and then screw the back plate back into place.
To operate the P-5 with this remote control, you must first press
the button labeled 'Preamp' on the top right corner.
The
button located at the top center will switch the
POWER
preamplifier to either 'Stand by' or 'On' mode.
The
button performs in exactly the same way as the 'Input'
INPUT
button located on the P-5's front panel, sequentially cascading
through each of the preamplifier's inputs.
The
and
VOL+
VOL–
the volume level.
The
and
buttons control channel balance; Pressing the left
arrow button causes a decrease in the volume level of the right
channel; pressing the right arrow button causes a decrease in the
volume level of the right channel.
The
button, located in the middle of the volume and balance
MUTE
buttons, performs the identical function as the 'Mute' button located
on the P-5's front panel.
The lower section of the 'FRM' allows for the direct access
selection of an input source. Only the buttons labeled
and
are applicable for operating the P-5.
A5
CD
buttons increase and decrease, respectively,
through
A1
12
Advertisement
Table of Contents
