Remote Control Operation - moon Neo 230HAD Owner's Manual

Owner's Manual

Remote Control Operation

The Nēo 230HAD Headphone Amplifier uses the 'CRM-2' full-function
remote control (figure 3). It operates on the Philips RC-5 communication
protocol and can be used with other Simaudio MOON components.
The 'CRM-2' remote uses two AA batteries (included). To install them, simply
slide the back plate off in the direction of the arrow; insert the batteries in the
correct direction and then replace the back plate.
To engage the 'CRM-2' remote for use with the Nēo 230HAD Headphone
Amplifier/DAC, you must first press the button labeled D/A.
The POWER button located on the upper left will switch the Headphone
Amplifier to either 'Standby' or 'On' mode.
The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all available inputs. For example, to switch
from the "A1" to the "B1" input, press ◄ INPUT two (2) times. To switch from
the "B1" to the "A1" input, press INPUT ► two (2) times. Pressing and holding
down either of these buttons results in only a single change to the selected
input.
The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level. Pressing
▼ VOL results in a decrease in the volume level; Pressing VOL ▲ results in an
increase in the volume level. You may either press and hold these buttons
down or press them briefly to make volume adjustments.
NOTES: The ◄ BAL ► buttons don't affect the operation of the 230HAD.
The MUTE button doesn't affect the operation of the 230HAD.
Figure 3: CRM-2 Remote Control
11