Cable Adjustment - Inspire LEG PRESS OPTION Assembly & Operation Manual

Step 15: Place Orthopedic Pad on Seat Base. Work the edge of pad into the groove
of the Seat Base on all sides. Do not use sharp objects during
installation.
Press Arm
Step 16:

Cable Adjustment

Thread the press arm stop so that there is one inch between the Press Arm and the Leg
Press Base, as shown in the diagram. Tighten the Jam Nut. Next thread the floating
pulley stop out until it contacts the floating pulley as shown in the diagram. Tighten jam
nuts on the floating pulley stop. After first weeks use and as needed, adjust cable slack
by alternately adjusting the floating pulley stop and press arm stop.
STEP 15
Orthopedic Pad
Seat Base
Press Arm
Jam Nut
Page 9
Assembled
Back & Seat Pad
Leg Press Base
Floating Pulley
Jam Nut