Inspire LEG PRESS OPTION Assembly & Operation Manual page 15

Press Arm
1 – 4 ¾" Hex Bolt
2 – 3/8" Flat Washers
1 – 3/8" Lock Nut
Step 10: Attach Pulley 3 to Press Arm using:
(Wrench Tighten Bolt)
Step 11: Attach Pulley 4 and retainer bolt to Base using:
(Wrench Tighten Bolts)
Step 12: Attach Cable End to Leg Press Base using:
(Wrench Tighten Bolt)
(Run Cable as shown in diagram. Make sure that the cable
is routed between pulley 4 and the cable retainer bolt.)
Step 13: Attach Floating Pulley Bracket Assy to Cable Using:
Thread the cable end through the hole in the Floating Pulley Bracket Assy and attach Cable
Adapter, as shown in diagram above. This will prevent the cable end from pulling through.
Floating Pulley Bracket Assembly
Pulley 3
STEP 12
Page 13
STEP 13
1 – Cable Adapter
Pulley 4
STEP 10
1 – 3 ½" Pulley
1 – 2" Hex Bolt
2 – 3/8" Flat Washers
1 – 3/8" Lock Nut
One (3 ½" Pulley)
One (2" Hex Bolt)
Two (3/8" Flat Washers)
One (3/8" Lock Nuts)
One (3 ½" Pulley)
Two (3 ¾" Hex Bolt)
Two (1" Step Spacers)
Two (3/8" Flat Washers)
Two (3/8" Lock Nuts)
One (4 ¾" Hex Bolt)
Two (3/8" Flat Washers)
One (3/8" Lock Nut)
STEP 11
1 – 3 ½" Pulley
2 – 3 ¾" Hex Bolts
2 – 1" Step Spacers
2 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
One (Cable Adapter)