Inspire LEG PRESS OPTION Assembly & Operation Manual page 14

STEP 8
1 – 4 ¼" Hex Bolt
1 – 3/8" Flat Washer
Press Arm
Leg Press Base
1 – 3 ½" Pulley
STEP 9
1 – 2" Hex Bolt
2 – 3/8" Flat Washers
1 – Pivot Shaft
1 – 3/8" Lock Nut
Step 4: Attach Pulley 2 to Leg Press Base using:
Two (3/8" Flat Washers)
One (3/8" Lock Nut)
Step 5: Secure Attachment Arm & Swivel Pulley Bracket to Main Upright using:
Two (4 ¼" Hex Bolts)
Four (3/8" Flat Washers)
Step 6: Secure attachment arm to main upright using:
One (3 ½" Pulley)
One (3 ¾" Hex Bolt) Two (3/8" Flat Washers)
Note: Re-install Pulley 1 and 1" Barrel Spacer in original location
Step 7: Secure Attachment Arm to Leg Press Base using:
(Finger Tighten Only)
Step 8: Secure tubular portion of Attachment Arm to Leg Press Base Using:
(Wrench Tighten Bolts in Steps 5-8 Now)
Step 9: Attach Press Arm to Leg Press Base using:
(Tighten Allen Screws using 4mm Allen Wrench Included)
STEP 7
2 – 5" Hex Bolts
2 – 3/8" Lock Nuts
4 – 3/8" Flat Washers
Pulley 2
Attachment Arm
STEP 4
(Wrench Tighten)
(Finger Tighten Only)
One (5/16" Barrel Spacer)
(Finger Tighten Only)
One (3 ½" Pulley)
One (2" Hex Bolt)
Two (3/8" Lock Nuts)
One (3/8" Lock Nut)
Two (5" Hex Bolts)
Four (3/8" Flat Washers)
Two (3/8" Lock Nuts)
One (4 ¼" Hex Bolt)
One (3/8" Flat Washer)
One (Pivot Shaft)
Page 12
5/16" Barrel Spacer
STEP 6
1 – 3 ¾" Hex Bolt
1 – 5/16" Barrel Spacer
1 – 3/8" Lock Nut
2 – 3/8" Flat Washers
STEP 5
2 – 4 ¼"Hex Bolts
4 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
One (1" Barrel Spacer)
Pulley 1 &
Barrel Spacer
1"
Swivel Pulley
Bracket