Inspire LEG PRESS OPTION Assembly & Operation Manual page 9

Step 7: Attach Pulley 2 to Arm Assembly using:
(Wrench Tighten Bolt)
Step 8: Attach Pulley 3 and retainer bolt to Base using:
(Wrench Tighten Bolts)
Step 9: Attach Cable End to Leg Press Base using:
(Wrench Tighten Bolt)
(Run Cable as shown in diagram. Make sure that the cable
is routed between pulley 3 and the cable retainer bolt.)
Step 10: Attach Floating Pulley Bracket Assy to Cable Using: One (Cable Adapter)
Thread the cable end through the hole in the Floating Pulley Bracket Assy and attach Cable
Adapter, as shown in diagram above. This will prevent the cable end from pulling through.
Floating Pulley Bracket Assembly
Pulley 2
STEP 9
1 – 4 ¾" Hex Bolt
2 – 3/8" Flat Washers
1 – 3/8" Lock Nut
STEP 10
1 – Cable Adapter
Pulley 3
STEP 7
1 – 3 ½" Pulley
1 – 2" Hex Bolt
2 – 3/8" Flat Washers
1 – 3/8" Lock Nut
Page 7
STEP 8
1 – 3 ½" Pulley
2 – 3 ¾" Hex Bolts
2 – 1" Step Spacers
2 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
One (3 ½" Pulley)
One (2" Hex Bolt)
Two (3/8" Flat Washers)
One (3/8" Lock Nuts)
One (3 ½" Pulley)
Two (3 ¾" Hex Bolt)
Two (1" Step Spacers)
Two (3/8" Flat Washers)
Two (3/8" Lock Nuts)
One (4 ¾" Hex Bolt)
Two (3/8" Flat Washers)
One (3/8" Lock Nut)