Rear Panel - Datavideo HDR-200 User Manual

Rear Panel

2 channels XLR Balanced Audio input & output.
This audio will also be passed to the HDMI and HD-SDI outputs.
The GPI socket can be used for simple external control. The HDR-200
can accept pulse or level trigger inputs, which can trigger record or
playback or pause commands. See GPI Mode & Function Menus for
more details.
RS-422 Port. The HDR-200 can be controlled via RS-422 from external
devices. The HDR-200 uses standard Sony protocol. Connect the RS-
422 control cable to this port.
NB: The RP-36 panel on the rear of the HS-1000 has an RS-422 port
which is directly wired to the SE-1000 mixer. Please contact your
local Datavideo office if you also wish to control the HDR-200 via
RS-422 within the HS-1000 set up.
6 Pin DV In/Out Port. This is a convenient rear mounted DV / IEEE Port
for connection to PC for file transfer.
HD- YUV component analogue input and output connecters.
HDMI Out Ports. Ports for connecting to HDMI external devices.
HD-SDI output connecters.
HD- SDI input and pass-through output connectors.
DC In Socket. Connect the supplied 12V 3A PSU to this socket. The
connection can be secured by screwing the outer fastening ring of the
DC In plug to the socket
Power On/Off Switch. Switches the power On / Off
Grounding Terminal. When connecting this unit to any other component,
make sure that it is properly grounded by connecting this terminal to an
appropriate point. When connecting, use the socket and be sure to use
wire with a cross-sectional area of at least 1.0 mm2.
7