Playing A M2T Track; Recording A Track - Datavideo HDR-200 User Manual

Playing an M2T Track
It is playback M2T tracks to analogue monitors or recorders via the HD(YUV), HD-SDI or HDMI video
outputs.
Use the Previous (▲) / Next (▲) Button(right)s to select the track you want to play, and then press the Play
(►II) Button.
It is also possible to set the HDR-200 to loop play. In loop play the track will seamlessly looped until stopped.
To set up loop play press the Menu Button to enter menu mode and then the FWD (►►) Button until SETUP
LOOP PLAY is displayed.
+
Press the Next (▲) Button(right) to enter the setup loop play menu, and then press the FWD (►►) Button to
select ENABLE
Press the Next (▲) Button(right) to select SET and then press the Menu Button to return to track display.
When you press play the selected track will start playing, and will loop until the Stop (■) Button is pressed.
To cancel loop playback, follow the above procedure but select disable instead of enable.

Recording a track

To record from an analogue video source you first need to set the analog input – see Video Input Source
Menu for more details.
Press the Video Input Button so that it is illuminated. You should see the video source on your output monitor
Use the Next / Previous Buttons to select an empty track from the HDR-200 track list, one that shows a
duration of 00:00:00:00 in the LCD display.
Press both the Record and Play/Pause Buttons simultaneously and the HDR-200 should start recording.
+
If it does not start recording check the following:
There is an analogue video input present.
The Video Input Button is illuminated
Not suitable - Track
has been recorded
18
The counter should start counting and the REC
symbol should appear
Suitable - Track is
empty