Rear Panel
The Input Select Switches can be set to CV (Composite Video) or S (SVideo
(Y/C)). Always use SVideo if available. Set each input according to the video
signal you are connecting.
CAM1 (GREEN) and CAM2 (BLUE) Video Inputs for connecting the two
foreground video images. There are Composite and SVideo Inputs, at the top
and Composite and SVideo Loop Through outputs below. The SVideo input can
be monitored from the Composite Video Loop Through if required.
The SVideo
Loop Through is only active if the SVideo input is used.
N.B. For best results always use an SVideo signal if available.
Background Input (BG Input) for connecting the video feed from your background
source. This could be from a VTR or DVD player for example. The Composite
and SVideo Inputs are at the top, and the Loop Through Outputs are below. The
SVideo input can be monitored from the Composite Video Loop Through if
required.
The SVideo Loop Through is only active if the SVideo input is used.
The Main Video Output shows the final result of the keyer. There are two
composite outputs and one SVideo (Y/C), all three are active simultaneously. It
is advisable to connect a monitor to one of the outputs so that you can see
exactly what the DVK100 is outputting.
Power Switch, switches the DVK100 on/off.
DC In. Connect the power supply to the DC In, there is a locking collar on the
power supply lead which screws onto the socket to ensure a positive connection.
It is also possible to power the DVK100 from a suitable 12V Battery Pack, but
please ensure that the power is regulated.
Grounding Terminal.
When connecting this unit to any other component, make sure that it is properly
grounded by connecting this terminal to an appropriate point. When connecting,
use the socket and be sure to use wire with a crosssectional area of at least 1.0
mm2.
Dip Switches / Mode Select
The DVK100 can be set to various modes using the Dip Switches.
10