AMT Datasouth Fastmark M7 Series User Manual page 44

Gap Mode 3/4
Manual
> Pre-Printed
Exit
When enter [Pre-Printed] option, you will see following message. Please
complete there steps
Paper Len.
00812 dot
Gap Size
0024 dot
Gap Mode
Pre-Printe
1. Press the
left digit to right digit, and press the
the value from "0" to "9" and the "dot/ mm/ inch". Press the
button to set the paper length into the printer.
2. Press the
digit to right digit, and press the
value from "0" to "9" and the "dot/ mm/ inch". Press the
button to set the gap size into the printer.
3. Then, printer will feed labels to calibrate the sensor
sensitivity automatically. When calibration is completed, the
LCD screen will return to the previous menu.
Page 44 of 73
button to move the cursor from
button to set
button to move the cursor from left
button to set the