AMT Datasouth Fastmark M7 Series User Manual page 35

3.1.1.1 Speed:
Print Setup
> Speed
Density
Direction
Use this option to setup print speed. The available print speed is between 4~12 ips
and each increament/decreament is 1 ips. The default print speed is 6 ips.
Press key to raise the print speed, and press
speed. Press
setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the SPEED command, which will overwrite the setting set from the
front panel.
3.1.1.2 Density:
Print Setup
Speed
> Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15, and
the step is 1. Printer default density is 8.You may need to adjust your density based
on selected media and ribbon type.
Press and
key to enable the setting. Press
return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the DENSITY command, which will overwrite the setting set from the
front panel.
3.1.1.3 Direction:
Print Setup 3/12
Speed
Density
> Direction
The direction setting value is either 1 or 0. Use this option to setup the printout
direction. Printer default printout direction is DIRECTION 0.
Press key to set the direction as 1, and
key to enable the setting. Press
the previous menu.
1/12
key to set it into printer. Press
2/12
Density
8
to increase/decrease the printing darkness. Press
Direction
0
Page 35 of 73
Speed
6
key to cancel the setting and
to set it as 0, and
key to cancel the setting and return to
key to decrease print
key to cancel the