AMT Datasouth Fastmark M7 Series User Manual page 37

Cutter Batch
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1.5 Offset:
Print Setup 5/12
Direction
Print Mode
> Offset
This option is used to fine tune media stop location. Press the
move the cursor from left digit to right digit, and press the
value from "+" to "-" or "0" to "9". Press the
printer. Press
The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the OFFSET command, which will overwrite the setting set from the
front panel.
3.1.1.6 Shift X & Shift Y:
Print Setup 7/12
Offset
Shift X
> Shift Y
This option is used to fine tune print position. Press the
cursor from left digit to right digit, and press the
"+" to "-" or "0" to "9". Press the
key to cancel the setting and return to the previous menu. The default
value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the SHIFT command, which will overwrite the setting set from the
front panel.
Cut the label once at the end of the printing job.
Offset
+000
key to cancel the setting and return to the previous menu.
Shift Y
+000
button to set the value into printer. Press
Page 37 of 73
button to
button to set the
button to set the value into
button to move the
button to set the value from