AMT Datasouth Fastmark M7 Series User Manual page 42

A. Gap Mode
Calibration 1/4
> Gap Mode
Bline Mode
Cont. Mode
Press the and
the button to enter the sensor calibration mode.
Note: If printing from enclosed software/driver, the software/driver will send
out the GAP or BLINE command, which will overwrite the sensor type
setting set from the front panel.
A-1 Automatic
When enter the [Automatic] option, you will see following message, and printer
will feed 2 to 3 gap labels to calibrate the sensor sensitivity automatically.
When calibration is completed, the LCD screen will return to the previous
menu.
Gap Mode
Automatic
In case "Automatic" sensor calibration cannot apply to the media, please use
"Manual" function to calibrate the gap sensor manually.
Gap Mode
Automatic
> Manual
Pre-Printed
When enter [Manual] option, you will see following message. Please complete
there steps
Paper Len.
00812 dot
Gap Mode 1/4
> Automatic
Manual
Pre-Printed
buttons to scroll the cursor to the media type and press
A-2 Manual
2/4
1. Press the
from left digit to right digit, and press the
button to set the value from "0" to "9" and the
"dot/ mm/ inch". Press the
the paper length into the printer.
Page 42 of 73
button to move the cursor
button to set