AMT Datasouth Fastmark M7 Series User Manual page 46

Bline Mode
Scan Mark
Intensity
Ref. Level xxx
Bline Mode
Scan Paper
Intensity
Ref. Level xxx
Note:
Normally, the value of "Ref. Level" for mark should be larger than paper for over 128.
If the media sensor fails to do so, you have to manually change the Intensity by
pressing and
Bline Mode
Complete
Intensity
Ref. Level xxx
3. Open the print head mechanism, put the black
Mark under the media sensor. Press the
button to set the value into the printer.
Media sensor
Black mark
4. Then, put the label without black mark under the
media sensor. Press the
value into the printer.
Media sensor
Label without
black mark
to reach the above value.
5. The bline sensor calibration is complete. Press
The
to the previous menu.
Page 46 of 73
button to set the
button the LCD screen will return