Configuring Cos (Cli); Mapping Table Configuration - Dell PowerConnect 8024 User Configuration Manual

Configuring CoS (CLI)

This section provides information about the commands you use to configure
CoS settings on the switch. For more information about the commands, see
PowerConnect 8024/8024F CLI Reference Guide
the
support.dell.com/manuals.

Mapping Table Configuration

Beginning in Privileged Exec mode, use the following commands in to
configure the CoS mapping tables.
CLI Command
configure
interface
interface
classofservice dotlp-mapping
priority
classofservice trust {dot1p |
ip-dscp | untrusted}
exit
exit
show classofservice dotlp-
mapping
show classofservice ip-dscp-
mapping
show classofservice trust
Description
Enter Global Configuration mode.
Enter Interface Configuration mode, where
interface
is replaced by tengigabitethernet
unit/slot/port
or port-channel
Map an 802.1p priority to an internal traffic class for
a switch. You can also use this command in Global
Configuration mode to configure the same
mappings on all interfaces.
Set the class of service trust mode of an interface.
Exit to Global Config mode.
Exit to Privilege Exec mode.
Display the current Dot1p (802.1p) priority
mapping to internal traffic classes for a specific
interface.
Display the current IP DSCP mapping to internal
traffic classes for a specific interface.
Display the current trust mode setting for a specific
interface.
Configuring Class-of-Service
at
port-channel number
.
1115