Mcp-601 Ir Controller Screen - Magni MCP-601 Operator's Manual

MCP-601 Operator's Manual
screen. Follow the instructions under the Save Configuration Memories screen to Save or Recall a
memory.
Figure 7-2, Save Configuration screen by pressing the Save Memories button
Memories can only be reset to factory default settings in two ways: 1) Through the Menu button on the
remote IR controller or the MCP-601 IR button on the Config screen of the Magni Premier software
(refer to the section on MCP-601 Video output on-screen displays), or 2) With the Command and
Control Codes listed on page 29. Please refer to Table I, MCP-601 Factory Preset Memories for detail
of each factory default memory setting. Refer to Section 6. IR Remote Controller for more detail of the
controller operations.

MCP-601 IR Controller Screen

For the convenience of the software user, the IR Remote Controller functions are being duplicated in
the software. To activate the MCP-601-IR screen, press the MCP-601-IR button in the Config screen.
NOTE: The MCP-601 IR button is active only in RS232
connection mode and are disabled when the unit is
operating via USB connection.
Figure 7-3, The MCP-601-IR screen under the Config screen simulates the hardware controller.
Magni Systems, Inc. 58