MCP-601 Operator's Manual
This chapter identifies the MCP-601 components that were shipped from the factory. This chapter also
describes how to install the MCP-601, connect the MCP-601 to a computer, and how to install the Magni
Premier application software.
MCP-601 Components
The following MCP-601 components were shipped from the factory. Before proceeding, carefully unpack the
contents and verify the condition of each component.
If any component is missing or damaged, contact your nearest authorized dealer or Magni for information
about replacing parts.
Component
MCP-601 Main Unit (1)
MCP-601 IR Controller (1) with 4 AAA batteries
FX-1 Controller (1)
Installation CD-ROM (1)
DVI-D to DVI-D connecting cable (1)
DB-15P to DB-15P VGA male-to-male cable (1)
Dsub RS-232 connecting cable (1)
AC Power cord (1)
Operator's Manual (1)
Rack mounting ears (2)
Installing the MCP-601 into a Rack
The MCP-601 mounts into any industry-standard rack. To install the MCP-601:
Install the rack mounting ears onto the MCP-601.
Insert the MCP-601 into the rack and then secure it using the supplied screws
CAUTION:
a lot of air space. However, installing it in between two devices that
produce a high amount of heat might cause overheating.
For optimal performance, keep the top cover air flow unrestricted.
Magni Systems, Inc.
4. INSTALLATION
*Optional for OEM version
xx denotes updated version
Table 4-1. MCP-601 Components
The MCP-601 produces very little heat and does not need
Magni Part #
670-0245-00 *
670-0240-00 *
840-0301-xx
330-0116-00
330-0117-00
330-0103-00
340-1100-80
946-5401-xx
485-0406-20
21
.