Magni MCP-601 Operator's Manual page 53

MCP-601 Operator's Manual
Horizontal
VGA ONLY: All analog VGA modes (USER, VGA, SVGA, XVGA, SXVGA, UXGA)
AutoPos now: MCP-601 sets the position of graphic relative to the blue graphics size.
AutoPos Enable:
ON* enables auto positioning of VGA display when the unit recognizes there is a
OFF retains previous positioning data and only repositions on command.
References: This section provides the VGA resolution information (including the DVI and
user entered)
USER Indicates user setting for special VGA modes. These settings are entered
VGA, SVGA, XVGA, SXVGA, UXGA, DVI
NOTE: In auto-detect mode, the MCP-601 will show one or more possible VGA display
resolutions. Select the one closely matched your VGA input display resolution.
INPUT VIDEO:
No Input-- This is the scan conversion mode. This setting is also in effect when loss of input
Default STD: Selects NTSC* or PAL output standard when input video is not present.
NTSC selects 525/ 60 standard when no input present.
PAL selects 625/50 standard when no input present.
Input None
Genlock Source: Select REF (reference) or Internal Clock* when input video-None is selected
REF selects the REF IN Composite analog signal as the genlock source.
Internal selects the internal clock as the genlock source.
SDI Input: This is the SDI input, graphics conversion or key and video overlay mode.
Genlock Phase: Selects the subcarrier phase reference for the analog Composite output.
SDI
REF*
Magni Systems, Inc.
Horizontal filtering
Off No filtering
On ¾ to ¼ weighting per data sample
display changed.
through the IR remote controller, Magni Premier software or via RS232.
Indicates graphics modes that have been automatically detected.
video occurred.
SDI and analog outputs are both genlock to the SDI input and the
Composite output video is line locked to the SDI input.
SDI and Component output are genlock to the SDI input, while Composite
output video is phase locked to the REF IN analog video reference. This
reference input must line-locked to SDI input and only affects the analog
Composite output . Otherwise it must be set to SDI for a stable output display.
Select this setting to stabilize the phase of analog video output in the presence
of noise and keeps the color frame of output relative to the input.
53