Recommendation For Menu Operational Settings - Magni MCP-601 Operator's Manual

MCP-601 Operator's Manual
Analog Input
Genlock Bandwidth: Select analog input bandwidth and genlock filter mode:
Broadcast*
VTR
TV
CUTOUT: Sets the size of the graphics cutout in the reduced size video.
Offsets: Set the graphics cutout size to overlay the blanking area of incoming video so that
black or vertical interval signals will not show on the output picture while allowing
maximum video picture size. There are four offset settings:
Offset Left and Offset Right, defined the number of pixels from the picture edge.
Offset Top and Offset Bottom, defined the horizontal lines from the picture edge.
SERIAL PORT: Settings for serial communication port
Handshaking
Baud Rate
SYSTEM IDS: Indicates the revision and date codes of the firmware.
Loader
Software
Alex
Babel
Hardware
Serial Number

Recommendation for MENU Operational Settings:

DISPLAYS, Filters, Flicker, Reduced
DISPLAYS, Filters, Horizontal, On
DISPLAYS, VGA Only, AutoPos Enable, ON
INPUT VIDEO, No Input, Default STD, NTSC or PAL depends on TV standard.
INPUT VIDEO, No Input, Genlock Source, REF
INPUT VIDEO, SDI Input, Genlock Phase, REF
INPUT VIDEO, Analog Input, Genlock Bandwidth, Broadcast or VTR or TV depends on the
Magni Systems, Inc.
This is the analog input graphics conversion, or key and video overlay
mode. SDI and analog outputs are always genlock to the selected analog
input.
Setup for full bandwidth studio video signals that are relatively stable.
Setup for signals from VTR that have horizontal to subcarrier timing
variations.
Setup for off-air signals that have both noise and timing variations.
Xon/Xoff
NONE*
9600, 19200, 28800, 38400, 57600, 115200*
Hardware ID identifies the product model
Serial number of the unit.
54
facility setup.