Con Guring Wireless Printing Using Fingerprint - Intermec PB51 User Manual

4 If you are using TTLS, you may need to send this co mmand to set
5 If you are using certi cates for validation, here are some

Con guring Wireless Printing Using Fingerprint

Use the following procedures to con gure your PB51 with
Fingerprint for wireless printing.
PB51 Mobile Label and Receipt Printer User's Guide
where xxxx is the unique username and the unique password for
this protocol.
the TTLS outer name:
<STX><SI>ws,TTLS_USER,
where xxxx is the outer name.
commands you may need to use.
Send the following commands to set a certi cate and enable
validation:
<STX><SI>ws,CA_CERT,
<STX><SI>ws,VALIDATE,ON<ETX>
where c:/testCA.pfx is the location and name of the certi cate
and export is the passphrase.
Send the following commands to set a common name for
server 1 and server 2:
<STX><SI>ws, .SERVER_CN1,
<STX><SI>ws, .SERVER_CN2,
where xxxxxxxxxx can be a value from 0 to 64 characters.
Send the following command to make sure your values match
those used by the access point:
<STX><SI>wt,[variable name]<ETX>
All variables are returned with the exception of EA P_PASS
which always returns "****" if con gured and CA_CERT
which transmits the name of the last certi cate au thority
successfully installed. An additional read-only var iable for the
supplicant state, called STATE, is also returned.
You may need to send the following command several times for
the wireless station to connect:
<STX><SI>ws,ACTIVE,1<ETX>
Chapter 2 — Con guring the PB51
<ETX>
xxxx
@
c:/testCA.pfx export
xxxxxxxxxx
xxxxxxxxxx
<ETX>
<ETX>
<ETX>
33