Printing Configuration Test Labels - Intermec 4630 User Manual

To set the low media warning
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓ until
2. Press Select and then press ↑ or ↓ until the display shows:
3. Press Select and then press ↑ or ↓ until the display shows:
4. Press Select. The display shows the current setting for the Low Media Warn
5. Press ↑ to increase the digit or press ↓ to decrease the digit. Press Select to
6. Press Enter when you have the value you want.
7. Press Menu and then press ↑ or ↓ until the display shows:
8. Press Select and then press ↑ or ↓ until the display shows:
9. Press Enter to enable the Low Media Warn command and then press Cont

Printing Configuration Test Labels

To review the current configuration of the printer, you can print a
Configuration Test Label that shows either the user-defined software or
hardware configuration of your printer.
User-Defined This label lists the current configuration parameters that are set
from the Configuration, Operator, and Install menus, as well as defined pages,
formats, graphics, and fonts. Any printer options that you have installed are
also listed on this label.
Hardware This label lists the amount of memory installed in your printer
(static and dynamic RAM), the width and dot size of the printhead, and the
printhead mileage. The printhead mileage consists of both the amount of media
that has been processed (passed underneath the printhead) and the amount of
media that has been burned (printed).
you reach the Configuration menu.
CONFIGURATION
MEDIA ALERT
MEDIA ALERT
LOW MEDIA WARN
command with the cursor under the first digit.
move the cursor to the next digit.
MEDIA ALERT
SET WARNING
SET WARNING
ENABLED
to return to the OFFLINE READY display.
Operating and Configuring the Printer
2
2-25