Table of Contents
Advertisement
ALIGNMENT & A D J U S T M E N T S
6.4.3 Data Setup
SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
Caution : The Send Fax Level is set for optimum performance when shipped from the factory. Never
change settings arbitrarily.
MODEM SPEED
You can set the maximum modem speed.
Modem speed is automatically set to the lower speed when communicating with a slower speed modem
since communication is done using the standard of lowest speed unit to ensure proper
transmission/reception. Speed is best set 33.6Kbps as the default setting.
ERROR RATE
When the error rate is about to exceed the set value, the Baud rate automatically adjusts to 2400 bps.
This ensures that the error rate remains below the set value.
You can select the rate between 5% and 10%.
CLEAR ALL MEMORY
The function resets the system to the factory default settings.
This function is used to reset the system to the initial values when the product is functioning abnor-
mally. All the values are returned to the default values, and all the information, which was set by
the user, will be erased.
< Method >
1. Select the [MEMORY CLEAR] in the TECH MODE.
2. Push the ENTER button.
3. Select your country. (There are four country groups. Refer to the table below.)
4. Push the ENTER button then it will clear all memory.
NOTICE : Always perform a memory clear after replacing the main board. Otherwise, the system
may not operate properly.
Country Group
Country
Service Manual
July 2003
USA/Canada
USA/Canada
UK
Mexico
Germany
Brazil
France
Italy
Spain
Austria
Netherlands
Belgium
Portugal
Sweden
Norway
Denmark
Finland
Switzerland
Greece
Ireland
Turkey
UK
Russia
Russia
india
Oman
Poland
Bangladesh
Kuwait
Moroco
Algeria
Pakistan
UAE
Bahrain
Srilanka
SaudiArabia
Chile
Peru
Argentina
Hungary
Romania
Bulgaria
Czech
Southafrica
Southafrica
WorkCentre PE16
Hide quick links:
Advertisement
Table of Contents
