Zoom Cable Modem/Router User Manual page 91

WEP Encryption
Shared Key
Authentication
802.1x Authentication
(only available when WEP
is enabled)
Network Key 1-4
Current Network Key
PassPhase
Generate WEP Keys
Guest LAN Settings
IP Address
Subnet Mask
Lease Pool Start
Lease Pool End
Lease Time
UPnP Enable
Firewall Enable
DHCPv6 Server
to all clients. The re-keying process is the WPA equivalent
of automatically changing the WEP key for an AP and all
stations in a WLAN on a periodic basis.
WEP Encryption can be set to WEP 128-bit, 64-bit, or
Disable. Both the wireless clients and the Cable
Modem/Router must use the same WEP key.
Select Enable to enable. Shared Key authentication is only
available when WEP is enabled.
Select Enable to enable 802.1x authentication. Enable
802.1x Authentication only if you have a RADIUS server.
Most users will leave this as disabled.
You can pre-define up to 4 keys for 64-bit or 128-bit WEP.
64-bit keys require 10 hexadecimal digits and 128-bit key
require 26 hexadecimal digits.
Select one of the four pre-defined keys as the current
network key.
Enter a word or group of printable characters and click
Generate WEP keys to generate WEP encryption key.
These characters are case sensitive.
Click to generate 4 WEP keys automatically.
Select LAN for existing LAN - same as Primary Network - or
GUEST to create a Virtual LAN
Enter the IP address to be the default Cable
Modem/Router address for clients connected this guest
network.
Enter the subnet mask for this guest network.
Enter the start IP address of this DHCP address pool.
Enter the end IP address of this DHCP address pool.
Enter the leased time for DHCP clients. DHCP clients will
resend DHCP request before expiration. Maximum value
is 86400 seconds.
Select Enabled to enable UPnP on your guest network
Enables or Disables the Firewall on your guest network.
Selecting Enabled allows the DHCP server to assign IPv6
addresses.
91
.