Zoom Cable Modem/Router User Manual page 112

You may need to switch the Sideband for Control Channel setting from
lower to upper to access the higher channels.
5
Be sure to click Apply after you change the channel. All devices
connecting wirelessly will automatically switch to the new channel.

If changing the wireless channel did not help you should reduce the amount of
bandwidth your wireless connection is using from 40 Mhz to 20 Mhz. To do that,
follow these steps:
1
Open the Zoom Configuration Manager by entering the following in your
Web browser's address bar:
2
In the Login dialog box, type the following User Name and Password in
lower case, then click Login.
3
Click Wireless on the menu bar to open the Wireless page. On the Radio
page, from the Bandwidth drop-down menu, select 20 Mhz
4
Click Apply.
Problem
I followed the instructions for connecting the Modem/Router and entered
http://192.168.0.1 in my web browser's address bar, but I cannot access the
Modem/Router. (The Logon page does not appear).
Solution

Verify that power is on to the Modem/Router and that the Ethernet cable is plugged
between your Modem/Router and your computer's Ethernet (LAN) port.

Manually reset the Modem/Router. Insert a paper clip into the RESET opening on the
front panel, then press and hold down for 10 seconds. Then power off your computer
and power it back on. After you've done that, re-enter http://192.168.0.1 in your web
browser's address bar.

The computer connected to the Modem/Router must have it's TCP/IP parameters
setup to use DHCP (also called Dynamic IP). Check that your computer is setup to
use DHCP.
http://192.168.0.1
User Name: admin
Password: admin
112