Removal/Installation Of Hydrostatic; Transmission - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
3 Rider Pro 15 and Pro 18
5
3
• Attach a washer and circlip onto the swing axle
(1).
• Connect the brake wire (2) to the brake arm.
Tighten the brake wire nuts.
• Fit the linkage for the throttle control (3). Fix the
wire on the underside of the axle.
• Fit the drive belt over the pulley and attach the
spring to the tensioning roller (4).
Only Rider Pro 18
Connect the hydraulic hoses to the hydrostatic

transmission.

4
• Also check that the controls and cables are
properly adjusted, (see 'Checking and Adjusting
the Brake Cable' and 'Checking and Adjusting
the Accelerator Cable').
• Check and adjust the neutral position switch if
necessary.
• Fit the fan.
• Finally, fit the transmission cover.
40
– English
1
4
2
www.mymowerparts.com
Removing/installation of hydrostatic
transmission
1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
Only Rider Pro 18
Illustration, see 'Fitting Pendulum Shaft'.
• Clean, see 'Hydraulic system\Working methods'.
• Loosen the hydraulic hoses from the hydrostatic
transmission.
2 Rider Pro 15V2
• Loosen the idler's spring (1).
• Remove the fan (2); it is held in place by a circlip.
• Wiggle the drive belt off (3).
• Remove the oil tank (4).
• Loosen the hydrostatic transmission link (5) in
the forward ball joint.
• Remove the screw (6) that holds the arm.
• Remove the clutch control (7) and its spring.