Husqvarna Rider 15V2 Workshop Manual page 42

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
2 Rider Pro 15 and Pro 18
• Remove the nut (2), and lift off the washer and
fan from the input axle.
• Remove the oil tank and hose from the
hydrostatic transmission.
• Remove the disengaging control with its spring.
3 Rider 15V2
• Loosen the brake cable spring and remove the
brake cable from the brake lever (hidden under
the oil tank).
3 Rider Pro 15 and Pro 18
4
2
1
3
www.mymowerparts.com
• Disconnect the tensioning roller spring (1) and
prise off the drive belt.
• Release the speed control linkage (2) (on the
underside) and release the wire from underside
of the axle.
• Release the speed control linkage (on the
topside) from the hydrostatic transmission arm.
• Release the brake wire (3) spring and nuts. Prise
the wire off the brake arm.
4
Insert a garage jack under the hydrostatic transmis-
sion and loosen its five holder screws.
The rear retaining screw is placed in the front edge
of the bumper.
5
• Lower the garage jack and pull out the
hydrostatic transmission.
• Installation of the hydrostatic transmission is
carried out in the reverse hydrostatic transmis-
sion removing order
• After replacing, check that the brake wire and
speed control are correctly adjusted (see
Checking and adjusting of brake wire" and
"Checking and adjusting of speed control").
Check also the oil level in the tank, and bleed or
top up if necessary.
• Check and adjust the neutral position switch if
necessary.
• Check the hydrostatic transmission's oil level
after test running, and top up if necessary.
Reparation instructions
41
English –