Maintenance Schedule - Husqvarna Rider 15V2 Workshop Manual

Hide thumbs Also See for Rider 15V2:

Operator's manual (56 pages)

Operator's manual (56 pages)

Operator's manual (55 pages)

Table Of Contents

Table of Contents

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Delivery and dealer service

The following is a list of the maintenance which should be conducted on the machine. Most of the points that

are not covered by this workshop manual are covered by the operator's manual.

= Covered by this workshop manual.

= Not covered by this workshop manual or operating Instructions.

= Described in the operating Instructions.

Maintenance

Check for fuel and oil leakage

Check the parking brake

Check the engine oil level

Check the fuel pump air filter

Check the seat safety switch

Check the lift lever safety switch

Check the safety switch, pedal system

Check/clean the engine cooling air intake

Check the cutting unit:

•

blades are secure

•

condition of blades (sharpness,

shape, etc.)

•

blade synchronisation (90 between

BioClip)

Check steering wires (for play, etc.)

Check fasteners (screws, nuts, etc.)

Start engine and blades, listen for noise

Clean underside of cutting unit

Clean transmission air intake

Check battery acid level

Check transmission oil level

Check condition of V-belts, pulleys, etc.

Check for damage

Check tyre pressures (60 kPa/9,5 PSI)

Check for damage to wire guide at

articulated joint

Clean thoroughly around engine

Clean thoroughly around transmission

Clean all belts, pulleys, etc.

Lubricate belt tensioner (nipple)

Lubricate triangle link (nipple)

Lubricate joints and seat skid rails.

Lubricate all wires

Lubricate joints on cutting unit

Clean inside frame tunnel

Lubricate pedal mechanism inside frame

tunnel

Lubricate the gear control

Lubricate the parking brake wire

Lubricate throttle control

– English