For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Checking and adjustment of the throttle
wire
Check that the engine responds to the throttle
control and that the correct engine speed is
achieved at full throttle.
If adjustment is necessary, adjust the lower wire as
follows:
1. Release the clamping screw that secures the wire
casing and set the throttle control to full throttle.
2. Check that the throttle wire is attached to the correct
hole in the lower lever, see diagram.
3. Pull the throttle wire casing to the far left and tighten
the clamping screw.
www.mymowerparts.com
Checking and adjusting the choke wire
If the engine is producing black smoke or is difficult
to start then the choke wire (upper wire) may be
incorrectly adjusted.
If it is necessary to adjust the choke, proceed as
follows:
1. Release the clamping screw that secures the wire
casing and set the choke control to maximum
choke.
2. Check that the throttle wire is attached to the upper
lever, see diagram.
3. Pull the choke wire casing to the far right and tighten
the clamping screw.
Reparation instructions
35
English –