Refitting Hydrostatic Transmission Wire - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
6 Rider Pro 15 and Pro 18
Remove the locking spring at the rear linkage on
the hydrostatic transmission wire. Release the
clamp under the left drive shaft.
7
Lift off the linkage and pull out the wire.
8
Lift out the transmission wire with the linkage
attached.
9
Unscrew both ball joints from the hydrostatic
transmission wire.
www.mymowerparts.com
10
Remove the entire hydrostatic transmission wire.

Refitting hydrostatic transmission wire

1
Screw the front ball joint onto the new transmission
wire and tighten the lock nut.
2
Run the wire through the mower so that it follows
the same route as the old wire.
Reparation instructions
45
English –