Adjusting Cutting Height; Replacing Breakpin - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Checking and adjusting mower deck
ground pressure
1
Check tyre pressures 60 kPa/8,5 PSI.
Place a set of bathroom scales under the mower
deck's frame (front edge) so that the deck rests on
the scales.
2
Adjust the mower deck's ground pressure with the
adjusting nuts placed behind the front wheels on
both sides of the machine. The ground pressure
should be the same on both sides, between 12 and
15 kg/26,5-33 lb.
www.mymowerparts.com
Replacing the break-pin
(BioClip, Combi 103)
The blades are fitted with a break-pin to protect the
BioClip unit and its drive when colliding with
obstacles. A domed, spring friction washer is fitted
to each blade bolt. The washer must always be
replaced with a new washer when replacing the
shear pin. Otherwise the break-pin can break
causing the blades to collide.
Only use original spare parts. A set containing a
blade, break-pin and friction washer can be
purchased from your dealer.
1. Put the unit in the service position, see "Placing
in the service position".
2. Remove the blade (2A) by removing the blade
bolt with washer and friction washer (2B).
3. Remove the remains of the broken break-pin
(3).
4. Make sure the contact surfaces (4) on the blade
and the blade mounting are free from metal.
Clean if necessary.
5. Fit one new break-pin (5) in the blade
mounting.
6. Fit the blade (6), make sure it is fitted as
illustrated.
7. Fit a new friction washer (7) with the concave
face turned towards the blade.
8. Fit the blade bolt with washer (8). Tightening
torque 45-50 Nm/32-36 lbft.
2A
2B
Reparation instructions
5
3
4
6
4
7
8
53
English –