Removal Of Belt; Checking And Adjusting Mower Deck Ground Pressure - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
K62 / K66, filler hole
Replace the drain plugs. Fill with oil through the
filler hole. Replace the hose and fill the oil tank.
Bleed the hydrostatic transmission as shown in
"Bleeding the hydrostatic transmission's oil system".
Test run the machine and top up with oil to the
correct level in the oil tank.
Removing belt
Rider 15V2, Pro 15 and Pro 18
Starting point when removing belt:
• There is no deck mounted on the Rider.
• The front part of the belt is hanging loose.
The complete belt is only removed as shown below
when a snow blade is to be fitted on the Rider.
1. Release the belt guide and support belt pulley.
2. Release the wheel on the belt tensioner.
3. Take off the belt from the middle wheel and
remove the belt.
To fit the belt, follow the dismantling instructions in
the reverse order.
www.mymowerparts.com
Adjusting cutting height
• Loosen the nuts on the height setting arm.
• Place the rider on a level surface and measure
the distance between the ground and the edge of
the cutting unit, at the front of the housing.
• Adjust the height adjustment strut so that the
distance is:
- Bio 90, Bio 103, Combi 103
- Other units
• Tighten the nuts.
• Check that the parallelism has not changed. If it
has changed, the parallelism must be readjusted
again.
• Check and adjust the cutting unit's ground
pressure as set out (see "Checking and adjusting
cutting unit ground pressure") if necessary.
• Fit the nose.
IMPORTANT INFORMATION
The parallelism and height must be
adjusted again when changing the cutting
unit.
Reparation instructions
40 mm (1 7/16")
35 mm (1 3/8")
51
English –