For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
Adjusting cutting height area
1
3
11
1
Remove the right wing cover.
2
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm (3/
16"), the other fixed cutting heights will also be
raised by the same amount.
52
– English
2
www.mymowerparts.com
Checking and adjusting mower deck
parallelism
1
Check tyre pressures 60 kPa (8,5 PSI).
Place the ride-on mower on an even surface and
measure the distance between the ground and the
edge of the deck, at the front and rear of the cover.
The cutting unit should slope forwards slightly so
that the rear edge is 2-4 mm (1/8") higher than the
front edge.
2 Adjusting
• Remove the front cover and the right-hand
fender.
• Loosen the nuts on the parallel strut.
• Unscrew the strut (anticlockwise) to lower the
rear edge of the hood.
Screw the strut in (clockwise) to raise the rear
edge of the hood.
• Tighten the nuts after adjustment.
• On completion of the adjustment the unit's
parallelism should be re-checked.
• Fit the right-hand fender and the front hood.