Steering Wheel; Tow Plate; Oil Levels - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Delivery measures

Steering wheel

• Fit the steering wheel with the steering column
tube on the steering shaft.
• Screw in the socket head cap screw so that it
goes in the slot on the steering shaft. Work on
the steering wheel and tighten the socket head
cap screw so that it bottoms in the slot.
• Fit the lock nut on the socket head cap screw.

Tow plate

The tow plate is fitted the "wrong way round" at the
factory for transport reasons. Fit the tow plate on
the rear bumper as shown in the diagram.
Check the oil level in the engine
Check the oil level in the engine when the Rider is
standing horizontally with the engine switched off.
Lift up the engine cover.
Loosen the dipstick and pull it out. Wipe the dipstick
and replace it.
The dipstick should not be screwed down.
Loosen the dipstick and pull it out again. Check the
oil level.
The oil level should lie between the markings on the
dipstick. If the level is close to the "ADD" mark, top
up with oil to the "FULL" mark on the dipstick.
The oil is poured in the same hole the dipstick fits
in.
Use engine oil with the viscosity shown in the
diagram below, grade SF-SJ.
The engine takes a total of 1.5 litres of oil.
12
– English
www.mymowerparts.com